(ASCEND) BRI connection (fwd)

To: ascend-users@bungi.com
Subject: (ASCEND) BRI connection (fwd)
From: MegaZone <megazone@livingston.com>
Date: Fri, 28 Nov 1997 05:02:11 -0800 (PST)
Organization: WPI Discordian Society, Undocumented Cabal of the Accursed Saint Shiranto Joe
Sender: owner-ascend-users@max.bungi.com

Once upon a time Bench shaped the electrons to say...
>Can Max 4060 support BRI connections even if I don't have ISDN
>BRI network cards for it?  If yes, then how do I configure it?

BRI is a physical interface.  You can't use BRI without a BRI card to
plug into.

BRI is just one physical interface for ISDN, PRI is another.  If you 
really mean can a customer place a call from an ISDN call from a BRI
into a MAX - yes, the MAX terminates it on PRI.

>Would it be just setting the proper signal to ISDN? Currently
>we are using R2 signaling mode for an E1 line, we have one more

You can temrinate ISDN DOSBS calls on channellized T1, but off hand I'm
not sure if you can do ISDN into an R2 E1 line...

-MZ
--
Livingston Enterprises - Chair, Department of Interstitial Affairs
Phone: 800-458-9966 510-737-2100 FAX: 510-737-2110 megazone@livingston.com
For support requests: support@livingston.com  <http://www.livingston.com/> 
Snail mail: 4464 Willow Road, Pleasanton, CA 94588
++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>

Prev by Date: (ASCEND) Max4004 (5.0Ap36) and PacBell SuperTrunk
Next by Date: (ASCEND) BRI connection
Prev by thread: (ASCEND) BRI connection
Next by thread: (ASCEND) Max4004 (5.0Ap36) and PacBell SuperTrunk
Index(es):
- Main
- Thread