Hi, Sorry if this topic has been discussed before in this list. I'm sure you all know about the telnet prompt on the max, which gives a password prompt only - NO USERNAME prompt. I learnt there is an attribute "Service-Type Administrative 6" in radius, in which I can use radius for administrative access. Does anyone know where in the max should I toggle to enable this feature? I'm using image 5.0Ap4 and above. Appreciate any feedback. Regards, +---------------------------------------------------------------------------+ |R.Azrina R.Othman azrina@jaring.my Fax: +60(3)966-1898 | | Tel: +60(3)966-5000 | |MIMOS Bhd x4004 | |Technology Park Malaysia MYCERT : <A HREF="http://www.cert.org.my/">http://www.cert.org.my/</A> | |57000 Kuala Lumpur, Malaysia JARING (ISP): <A HREF="http://www.jaring.my/jaring/">http://www.jaring.my/jaring/</A>| | MIMOS : <A HREF="http://www.jaring.my/mimos/">http://www.jaring.my/mimos/</A> | +---------------------------------------------------------------------------+ ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request@bungi.com To get FAQ'd: <<A HREF="http://www.nealis.net/ascend/faq">http://www.nealis.net/ascend/faq</A>> </PRE> <!--X-MsgBody-End--> <!--X-Follow-Ups--> <!--X-Follow-Ups-End--> <!--X-References--> <!--X-References-End--> <!--X-BotPNI--> <HR> <UL> <LI>Prev by Date: <STRONG><A HREF="msg10426.html">(ASCEND) FCC restriction to 52000 bps</A></STRONG> </LI> <LI>Next by Date: <STRONG><A HREF="msg10423.html">Re: (ASCEND) Hayes Optima 28'800 V.FC + MAX 4000</A></STRONG> </LI> <LI>Prev by thread: <STRONG><A HREF="msg10565.html">Re: (ASCEND) Firmware for MAX 1800</A></STRONG> </LI> <LI>Next by thread: <STRONG><A HREF="msg10426.html">(ASCEND) FCC restriction to 52000 bps</A></STRONG> </LI> <LI>Index(es): <UL> <LI><A HREF="mail6.html#10425"><STRONG>Main</STRONG></A></LI> <LI><A HREF="thrd230.html#10425"><STRONG>Thread</STRONG></A></LI> </UL> </LI> </UL> <!--X-BotPNI-End--> <!--X-User-Footer--> <!--X-User-Footer-End--> </BODY> </HTML>