On Wed, Nov 05, 1997 at 03:04:57AM -0500, Jason Nealis wrote: > > I'm curious if any of you have seen the following , On my 1800's > I upgraded to AP33, I've had a number of failures, The boxes go into > a reboot cycle and never come out of it, Have you seen this? > > FATAL ERROR: Index: 19 Load: bi.m18 Revision: 5.0Ap33 > Date: 11/04/1997. Time: 20:01:16 > Location: b012678c b01270d4 b0127d48 b01c26b0 b01c2814 b0089878 > > WARNING: Index: 106 Load: bi.m18 Revision: 5.0Ap33 > Date: 11/04/1997. Time: 20:01:16 > Location: b017c924 b01a23a8 b01a45e8 b008b180 b008b0a8 b012678c > > FATAL ERROR: Index: 19 Load: bi.m18 Revision: 5.0Ap33 > Date: 11/04/1997. Time: 20:02:18 > Location: b012678c b01270d4 b0127d48 b01c26b0 b01c2814 b0089878 > > > fat > FATAL ERROR: Index: 19 Load: bi.m18 Revision: 5.0Ap33 > Date: 11/04/1997. Time: 20:01:16 > Location: b012678c b01270d4 b0127d48 b01c26b0 b01c2814 b0089878 > > WARNING: Index: 106 Load: bi.m18 Revision: 5.0Ap33 > Date: 11/04/1997. Time: 20:01:16 > Location: b017c924 b01a23a8 b01a45e8 b008b180 b008b0a8 b012678c > > FATAL ERROR: Index: 19 Load: bi.m18 Revision: 5.0Ap33 > Date: 11/04/1997. Time: 20:02:18 > Location: b012678c b01270d4 b0127d48 b01c26b0 b01c2814 b0089878 *BINGO* We should call this the Max1800 instobooting problem. We have seen this with several Max1800 units during the last months, first (and most in- tensely when upgrading to p13). These units, working perfectly up to the day the p13 was installed, crashed right during boot and got into a reboot loop (this is the death of unattended remote upgrades). We had units where a powerdown of some minutes caused the 1800 to come back alive and further cleansweeping of the config (fclear,trestore,fsave,nvram) seemed to cure it somewhat. We had a unit where only removal of the NVRAM backup battery got the unit back alive, but the unit crashed again after installing the previous config onto it (RMA'ed this one). When we had a chance to look on these faulty units we saw Net/BRI as "Not avail" - may be an indication of failing POST as seen with modem slots. This problem seemed to went away with anything after p13, but this may also have been a strange coincidence. May also be that it happens only now and then, and only to some range of S/Ns. Bad enough, it happened as well with p33 on one of our remote 1800s giving us a bad time (it's good to have relatives in towns where you install remote Ascends...). > Also another issue with AP33 is I'm getting Fatal Error #2's, > Have you seen these? > > Date: 11/04/1997. Time: 21:12:30 > NVRAM was rebuilt > > SYSTEM IS UP: Index: 100 Load: bi.m18 Revision: 5.0Ap33 > Date: 11/04/1997. Time: 21:12:53 > > FATAL ERROR: Index: 2 Load: bi.m18 Revision: 5.0Ap33 > Date: 11/04/1997. Time: 22:17:14 > Location: b017ca7c b0089438 b0089e34 b00a803c b00a80a0 b0088848 > > SYSTEM IS UP: Index: 100 Load: bi.m18 Revision: 5.0Ap33 > Date: 11/04/1997. Time: 22:18:21 Haven't seen this yet, but your base is mucho greater than mine - for you the "law of the big number" holds better ;) *Sigh* Andre. -- Kanther-Line: PGP SSH IDEA MD5 GOST RIPE-MD160 3DES RSA FEAL32 RC4 +-o-+--------------------------------------------------------+-o-+ | o | \\\- Brain Inside -/// | o | | o | ^^^^^^^^^^^^^^ | o | | o | Andre' Beck (ABPSoft) beck@ibh-dd.de XLink PoP Dresden | o | +-o-+--------------------------------------------------------+-o-+ ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request@bungi.com To get FAQ'd: <<A HREF="http://www.nealis.net/ascend/faq">http://www.nealis.net/ascend/faq</A>> </PRE> <!--X-MsgBody-End--> <!--X-Follow-Ups--> <HR> <STRONG>Follow-Ups</STRONG>: <UL> <LI><STRONG><A HREF="msg10531.html">Re: (ASCEND) Firmware for MAX 1800</A></STRONG></LI> <UL> <LI><EM>From</EM>: Jason Nealis <nealis@babylon.erols.com></LI> </UL> </UL> <!--X-Follow-Ups-End--> <!--X-References--> <STRONG>References</STRONG>: <UL> <LI><STRONG><A HREF="msg10419.html">(ASCEND) Firmware for MAX 1800</A></STRONG></LI> <UL> <LI><EM>From</EM>: "Troy Settle" <rewt@i-Plus.net></LI> </UL> <LI><STRONG><A HREF="msg10424.html">Re: (ASCEND) Firmware for MAX 1800</A></STRONG></LI> <UL> <LI><EM>From</EM>: Jason Nealis <nealis@babylon.erols.com></LI> </UL> </UL> <!--X-References-End--> <!--X-BotPNI--> <HR> <UL> <LI>Prev by Date: <STRONG><A HREF="msg10521.html">(ASCEND) Announce: traflogd-0.9</A></STRONG> </LI> <LI>Next by Date: <STRONG><A HREF="msg10518.html">Re: (ASCEND) Ascend stock (fwd)</A></STRONG> </LI> <LI>Prev by thread: <STRONG><A HREF="msg10424.html">Re: (ASCEND) Firmware for MAX 1800</A></STRONG> </LI> <LI>Next by thread: <STRONG><A HREF="msg10531.html">Re: (ASCEND) Firmware for MAX 1800</A></STRONG> </LI> <LI>Index(es): <UL> <LI><A HREF="maillist.html#10519"><STRONG>Main</STRONG></A></LI> <LI><A HREF="thrd230.html#10519"><STRONG>Thread</STRONG></A></LI> </UL> </LI> </UL> <!--X-BotPNI-End--> <!--X-User-Footer--> <!--X-User-Footer-End--> </BODY> </HTML>