Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
(ASCEND) Pools and static IP on same Radius?
Hiya,
Up until now I've been running Radius[-971222] user profiles with static
IP mappings, but now have the requirement to have a default profile with
a small pool of addresses.
I configured the appropriate lines into my 'users' file -
pools-mymax Password = "ascend", User-Service = Dialout-Framed-User
Ascend-IP-Pool-Definition = "1 12.34.56.78 15"
DEFAULT Password = "ACE", Ascend-Token-Immediate = Tok-Imm-Yes
Framed-Protocol = PPP,
User-Service = Framed-User,
Framed-Netmask = 255.255.255.255,
Ascend-Assign-IP-Pool = 1,
Ascend-Idle-Limit = 0
Which should work? Anyway, when I try and start PPP, MS DUN (under Win95)
complains "Dial-Up Networking could not negotiate a compatible set of
network protocols" and I see that I'm being given address 0.0.0.0 by
PPP.
Normally I'd blame all this on DUN, but using a radius profile with a static
IP address in it on the same PC and it works happily.
Anything I'm doing wrong? Can Radius run with Pool and Static entries?
Many thanks,
Aron
--
************** Aron Bibby Tel : +44 (0)117 922 9604
**** ***** Hewlett Packard Laboratories Fax : +44 (0)117 922 9742
** /_ __ *** Stoke Gifford Mobil: +44 (0)370 542 539
* / / /_/ ** Filton Road
** / *** Stoke Gifford EMail: aron_bibby@hp.com
**** ***** Bristol BS12 6QZ ab@hplb.hpl.hp.com
************** England aron@bibby.hpl.hp.com
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>