(ASCEND) P75 NAT setup

To: ascend-users@bungi.com
Subject: (ASCEND) P75 NAT setup
From: Daniel <daniel@lynx.bc.ca>
Date: Thu, 28 May 1998 14:21:22 -0700
Sender: owner-ascend-users@max.bungi.com

Hi folks,

I am setting up a P75 using NAT to connect to our Max4004. It works fine
with MPP . However, the P75 will automatically bring up a connection even
though there is no request for it. I have tested it by just connecting the
P75 to a network hub with serveral workstations (they are turned on but
idle). The P75 will connect then disconnect (after the idle timeout) and
connect again and repeat the cycle. However, when I unplug the network
cable from the network hub to the P75, it will not connect. What should I
do? Is that something to do with packet filtering?

While I was testing it, I connect it to our local LAN hub and when I turn
the "proxy mode" to "always", it crashes my local LAN stations. What
happens is on all other workstations, I got "arp info overwritten for
a.b.c.d by 0:2a:c:7b:ef:3a"
where the MAC address is the address of the P75. Once I turn it back to
"off", it is fine. Does anyone have this experience? (I am using NAT on the
P75)
Software 5.1A

Daniel


++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>

Follow-Ups:

Re: (ASCEND) P75 NAT setup

From: "Kevin A. Smith" <kevin@ascend.com>

Prev by Date: Re: (ASCEND) Nat won't, nailed ain't!
Next by Date: Re: (ASCEND) Nat won't, nailed ain't!
Prev by thread: (ASCEND) Answer: ISDN Seoul->Dublin
Next by thread: Re: (ASCEND) P75 NAT setup
Index(es):
- Main
- Thread