Re: (ASCEND) 7.0.26 must use assigned address somewhere?

["Daniel J. Vance" <techlists@rvi.net>]

Go to Ethernet -> Mod Config -> Wan Options

Scroll down to the bottom and make sure that Pool Only is set to yes.

Sincerely,
Daniel J. Vance
----- Original Message ----- 
From: Phil Bedard <philb@cyberlynk.net>
To: <ascend-users@bungi.com>
Sent: Monday, February 28, 2000 8:17 AM
Subject: (ASCEND) 7.0.26 must use assigned address somewhere? 


>       Does anyone know if somewhere in 7.0.x they have introduced a
> command to make it so the remote end must accept the assigned address?
> I upgraded a max4k to 7.0.26 from 6.0.8 and now a couple of users are
> getting their old IP addresses, which they have configured in their
> equipment.  They were getting the correct radius assigned ips until I
> upgraded to 7.0.26. 
> 
> Phil Bedard
> ++ Ascend Users Mailing List ++
> To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
> To get FAQ'd: <http://www.nealis.net/ascend/faq>
> 

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>