(ASCEND) P130 using NAT

To: ascend-users@bungi.com
Subject: (ASCEND) P130 using NAT
From: WCN Customer Service <cust.service@wcc.net>
Date: Fri, 14 Nov 1997 12:29:43 -0600 (CST)
In-Reply-To: <Pine.GSO.3.96.971114093641.2275A-100000@wcc.wcc.net>
Sender: owner-ascend-users@max.bungi.com


I came accross a P130 with 5.0Ai16. 

The my address field under configure is set to 130.10.1.1 because
130.10.1.2 is  what the person who configured it found on the internal
network server.
Should that work or does it mess up something because in
your
documentation you wrote:

Under "My Addr" enter a bogus IP address (i.e., an unregistered address on
your private network). This
    address must have three digits in each octet, e.g., 200.200.200.200/24
would work but
    200.99.200.200/24 would not. Make sure that the single workstation you
are connecting has an IP
    address on the same network. For example, if your Pipeline has an
address of 200.200.200.200/24,
    then set your workstation to an address of 200.200.200.201 with a
subnet mask of 255.255.255.0 

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>

References:

Re: (ASCEND) MaxTNT 1.3Ap6 ip/32 netmask bug

From: WCN Customer Service <cust.service@wcc.net>

Prev by Date: (ASCEND) MAX 4000 subnet mask
Next by Date: Re: (ASCEND) Diff between old and new P75s
Prev by thread: Re: (ASCEND) MaxTNT 1.3Ap6 ip/32 netmask bug
Next by thread: RE: (ASCEND) MaxTNT 1.3Ap6 ip/32 netmask bug
Index(es):
- Main
- Thread