Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
(ASCEND) MP+ calls - what are we doing wrong?
Hello
We have up until now had our clients using dial on demand ISDN calls
without SPCs (semi-permanent circuits).
Now some of them are changing to SPC calls and they no longer can
connect at any higher than 64K.
We have kept all the same settings and so on as from before, but the
first channel connects, and the all others terminate with error code
#16.
We found something in the manuals about
"The First call of an inverse multiplexing or MP+ call connects, but
then the call clears or does not connect on the remaining channels".
Its says that we need to put the local number to each Ascend unit
(max or pipeline) into the Line profiles PRI and SEC numbers.
Now, we've done this, but it still drops off channels.
We have lots of Max1800's in this senario being called by lots of
Pipeline 50s.
Any one have any suggestions?
adam
+-------------------------------------------------+
| Adam Neat |NOC Tel: 03-9887-1984 |
| National Systems Manager |NOC Fax: 03-9801-8533 |
| IPAX Systems - Australia |http://www.ipax.com.au|
| Mobile: 0414-348-187 |adamneat@ipax.com.au |
+-------------------------------------------------+
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>