No Subject

I don't think this is a reasonable request. If you want to run Quake and
NAT, then you must use Multi-IP NAT (atleast for P75 rev B). This is
perfectly fine if you have all the available IPs for you local network. 

However if you have a single IP (like me), need to get multiple machines
access to the Internet, have a Pipeline, and you want to run Quake then I
suggest the following. Configure the Pipe for Multi-IP NAT, connect the
router to a Linux box performing NAT/IP-Masquerade and the Quake module. 

Or just purchase a subnet... My ISP sells 2bit subnets for $4/mo, which
should get 2 machines Quake.

At 02:47 PM 11/1/97 -0800, Richard Johnsson wrote:
>Sounds like it's time for a feature request: Quake proxy for Pipeline
>50/75. Probably could only be done in the rev. B boxes that have more
>memory. :-)


++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	&lt;<A HREF="http://www.nealis.net/ascend/faq">http://www.nealis.net/ascend/faq</A>&gt;

</PRE>
<!--X-MsgBody-End-->
<!--X-Follow-Ups-->
<HR>
<STRONG>Follow-Ups</STRONG>:
<UL>
<LI><STRONG><A HREF="msg10355.html">Re: (ASCEND) Quake/QW and Pipeline 75 and NAT</A></STRONG></LI>
<UL>
<LI><EM>From</EM>: Jake Messinger &lt;jake@ams.com&gt;</LI>
</UL>
</UL>
<!--X-Follow-Ups-End-->
<!--X-References-->
<!--X-References-End-->
<!--X-BotPNI-->
<HR>
<UL>
<LI>Prev by Date:
<STRONG><A HREF="msg10352.html">(ASCEND) 5.0Ap33 results here...</A></STRONG>
</LI>
<LI>Next by Date:
<STRONG><A HREF="msg10350.html">Re: (ASCEND) Quake/QW and Pipeline 75 and NAT</A></STRONG>
</LI>
<LI>Prev by thread:
<STRONG><A HREF="msg10353.html">Re: (ASCEND) Quake/QW and Pipeline 75 and NAT</A></STRONG>
</LI>
<LI>Next by thread:
<STRONG><A HREF="msg10355.html">Re: (ASCEND) Quake/QW and Pipeline 75 and NAT</A></STRONG>
</LI>
<LI>Index(es):
<UL>
<LI><A HREF="maillist.html#10351"><STRONG>Main</STRONG></A></LI>
<LI><A HREF="thrd226.html#10351"><STRONG>Thread</STRONG></A></LI>
</UL>
</LI>
</UL>

<!--X-BotPNI-End-->
<!--X-User-Footer-->
<!--X-User-Footer-End-->
</BODY>
</HTML>