Very recently, I've noticed very weird problems dialing into my max. I have a PRI into a Meridian Option 11 PBX. One 800 number we have routes 8 channels over that PRI and then the PBX routes them to the Max. The max see's a full 24 channels from a PRI card in the Option 11 but only 8 remote dialins get routed over it. The other 16 channels are used by 8 pipeline 75's that dial a 4digit extension which routes them to the Max - just as if they had dialed in from remote. Here is the problem, the Pipelines don't seem to have any problems whatsoever 'calling' up. However, calls to the 800 number either get a fast busy, dead air for about 30 seconds before finally getting modem tones from the Max, or a single continuous ring. If I telnet into the Max and watch the console while dailing the 800 number, I see 'Assigned to Port' then 'Remote End Hungup' and I hear the fast busy on the phone line. I opened a trouble ticket up with MCI last Friday and they finally determined that it wasnt' a problem with the PRI and that the calls were being routed to our equipment correctly. I'm not quite so sure of that since teh calls that don't go over the PRI (ie, ISDN) connect with the max fine. The max has a single 8port V34 digital card in it running 5.0Ap23. Any comments or suggestions will be greatly appreciated.... Thanks, Jason Ledbetter Network Technical Specialist Applied Computer Technologies ++ Ascend Users Mailing List ++ To unsubscribe: send unsubscribe to ascend-users-request@bungi.com To get FAQ'd: <<A HREF="http://www.nealis.net/ascend/faq">http://www.nealis.net/ascend/faq</A>> </PRE> <!--X-MsgBody-End--> <!--X-Follow-Ups--> <!--X-Follow-Ups-End--> <!--X-References--> <!--X-References-End--> <!--X-BotPNI--> <HR> <UL> <LI>Prev by Date: <STRONG><A HREF="msg11139.html">(ASCEND) Assistance with Filters</A></STRONG> </LI> <LI>Next by Date: <STRONG><A HREF="msg11137.html">Re: (ASCEND) Max 5.0Ap36</A></STRONG> </LI> <LI>Prev by thread: <STRONG><A HREF="msg11134.html">(ASCEND) To any Dutch P75 users</A></STRONG> </LI> <LI>Next by thread: <STRONG><A HREF="msg11139.html">(ASCEND) Assistance with Filters</A></STRONG> </LI> <LI>Index(es): <UL> <LI><A HREF="maillist.html#11138"><STRONG>Main</STRONG></A></LI> <LI><A HREF="thrd255.html#11138"><STRONG>Thread</STRONG></A></LI> </UL> </LI> </UL> <!--X-BotPNI-End--> <!--X-User-Footer--> <!--X-User-Footer-End--> </BODY> </HTML>