Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: (ASCEND) Caller-ID Attribute missing
Located in Overland Park, KS. Our PRIs originate out of a switch in
Kansas City, MO about 10-15 miles away and then terminate at the CO near
here and are run to our office.
All of the PRIs are out of the same office and are in a hunt group
(actually two hunt groups but they roll over into one another)
Would like to believe it's as easy as that the CO isn't equipped to send
out Caller-ID but it doesn't look like that's the case. For example we
have a Nortel Meridian phone system that has a PRI connected to it (same
office) and we get Caller-ID about 98% of the time on it.
It also only happens on one of our Ascends (coincidence???) and after
running a 'diff' on all the other configs against this box, nothing came
up different (except IP addresses, etc.).
I need to get more info so I can figure out who to yell at- Ascend or
Bell. :)
-Rob-
> From: Scott Kozicki <scott@bluestar.net>
> Date: Fri, 24 Jul 1998 00:33:38 -0500
> Subject: RE: (ASCEND) Caller-ID Attribute missing
>
> >In every record? :)
> >
> >I probably should have been more clear; it is rare to see a Caller-ID
> >attribute in any of the logs but they are occasionally there. Get them
> >for either Sync or Async calls but never with any amount of consistency.
>
> Where are you located? It could be that you only have one CO that has a
> switch where CLID is installed. Calls from those exchanges would have the
> CLID, but other areas would not. Despite the BOCs claims to the contrary,
> there is still a good chunk of the public service telephone network that is
> running on shoddy out of date hardware.
>
> HTH,
>
>
> Scott Kozicki
> BlueStar Communications
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>