(ASCEND) Busy out all Modem Dial-in and still let in ISDN

[Raymond Brighenti <bargi@webfront.net.au>]

Hi all,

We have a situation where the Power at our main POP will be cut for a few 
hours. We have a Second POP connected via ISDN which won't have the power 
drop and will continue to accept calls once the main goes down but won't 
have any link to Authenticate or route with.

So is it possible to set a Max2000 so that any incoming Analog calls come 
up as busy but it still accepts ISDN (the only ISDN we have at this POP is 
the Link) so that when the main POP comes up again and dials it up it will 
allow it so that I can then enable the Analog lines again.(The second POP 
is about and hour away and the building will be inaccessible during the 
time of the blackout)

- If I go into the Modem settings in the Max and set Modemslot to dis slot 
for both cards will the unit still accept the calls but fail because it 
can't route the call to Modem card or will it be smart enough to busy out 
Analog calls?

Thanks

Ray





++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>