Re: (ASCEND) Pipeline 85 is dead after firmware update :-(

[Bob K <melange@yip.org>]

There should be at least two jumpers in there; try each of them.  JP9 is a
good candidate.  Note that your term program should be set to 57600, N, 8,
1 for it.

On Tue, 28 Sep 1999, Aron Bibby wrote:

> Hello,
> 
> In a red haze today I upgraded the firmware of a Pipeline 85 with a
> b.p75 load; after discovering it wouldn't boot, I then realised I should
> have used a b2.p75 load :-(
> 
> It won't boot, and after consulting the Ascend document (jumper P3) I
> also find I cannot NINDY (reset) it either.
> 
> Is there anything I can do, or is it RMA time?  It seems a shame to toss
> it in the corner and forget about it :-/
> 
> Many thanks,
> Aron
> -- 
> ************** Aron Bibby                    Tel  : +44 (0)117 312 9604
> ****     ***** Hewlett Packard Laboratories  Fax  : +44 (0)117 312 9742
> **  /_  __ *** Stoke Gifford                 Mobil: +44 (0)370 542  539
> *  / / /_/  ** Filton Road
> **    /    *** Stoke Gifford                 EMail:   aron_bibby@hp.com
> ****     ***** Bristol BS34 8QZ                      ab@hplb.hpl.hp.com
> ************** England                            aron@bibby.hpl.hp.com
> ++ Ascend Users Mailing List ++
> To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
> To get FAQ'd:	<http://www.nealis.net/ascend/faq>
> 

melange@yip.org - AT&T Canada Corp. - Internetworking Consultant

++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>