Re: [TCLUG:20355] have disk with win95

[Jeff Hallgren <jhallgren@abaton.com>]

	Partial success.. 
	I got the drives all switched around and everything appears correct.
Redhats hardware detection "Kudzu" is pretty nice and works well. It
noticed everything I did and allowed me to change config easily. 
	I now have an hdc that I can mount and browse under linux but I can't
boot from it. There must be something wrong with the boot record?
My lilo.conf 

boot=/dev/hda
map=/boot/map
install=/boot/boot.b
prompt
timeout=50
linear
default=linux

image=/boot/vmlinuz-2.2.14-5.0
	label=linux
	read-only
	root=/dev/hda5

other=/dev/hdc1
	label=win

	When I type "win" at the lilo prompt I get only:

Invalid system disk
Replace the disk, and then press any key

	Which seems like a pretty standard windows message 
	Any suggestions?


Magician wrote:
> 
> find the Master drive on that cable and set it to Slave or DS and put it on
> the Primary IDE controller
> 
> Ron W
> > Jeff Hallgren wrote:
> > >
> > > Okay, looks like I'll be running with the cover off for awhile...
> > > I'm going to try the "other IDE" port and set the drive to SP, I'll
> > > report back when and if I can ever reboot to linux again.
> > > Thanks.
> > > Jeff
> > >
> > Well that was quick.
> > Looks like I can only have 2 drives on that ribbon cable and I already
> > have a CDROM and a ZIP. I need both of those. Can I use/find a cable
> > with 3 connectors on it? or is that too much for the controller?
> >