(ASCEND) Problems with MAX OSPF and CISCOs ?

[Bill Hamel <bill@hamel.net>]

Hello,

I currently have 4 MAX 4004's talking OSPF to a CISCO 2514 on the same
ethernet where the 2514 is the DR with no BDR's.

I also have this same CISCO 2514 (IOS 11.2) talking OSPF to another 2501
(IOS 10.1) via a T1 Frame Relay on a sub interface Serial 1.3.

Everything works fine in that scenario.

I am now trying to get a MAX 4004 to talk OSPF to the CISCO 2501 via a T1
Frame relay connection where the MAX is a stand alone unit using the on
board router/CSU combination. OSPF is active.

I can't seem to get them to talk..... I have repeatedly looked at both the
ascend and cisco documentation and it looks like it should pretty much run
out of the box.

I have the 2 CISCO's configured as Broadcast over the frame and it works
fine. I can't seem to find a reason that the MAX will not neighbor with the
2501 over the Frame.

I made sure that the Hello and Dead intervals are the same.

I have OSPF configured on the stand alone MAX on the Ethernet side as well
as the "Connection" side.

Any input greatly appreciated.

Regards,
-Bill Hamel
++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>

---

• Prev by Date: (ASCEND) IPX Routeing
• Next by Date: (ASCEND) Pipeline 75, 2 channels, and ACO
• Prev by thread: Re: (ASCEND) Pipeline 75, 2 channels, and ACO (slight modify)
• Next by thread: (ASCEND) IPX Routeing
• Index(es):
  • Main
  • Thread