Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ASCEND) Max1800 5.0A=>6.1.7 upgrade misadventures
At 01:02 PM 9/3/98 , Jerry Swann wrote:
>Today, when I tried to upgrade a Max1800 from version 5.0A(b.m18)
>to version 6.1.7, the pilot number to the box stopped working and
>the serial hunt group no longer worked.
>
>The BRIs are off of a 5ESS switch. When we installed the lines
>BellSouth couldn't get a UCD set up correctly without creating a
>serial huntgroup among the lines. Because the UCD pilot wouldn't
>work with a calling card, we publish the first number in the serial
>huntgroup. All this worked until I upgraded the box.
>
>After upgrading, I could no longer get more than 1 user on the
>box with the serial huntgroup number, and further attempts caused
>a 'CALL REJECTED/OTHER DEST' error. I tried to down-grade (first
>to 5.0Ap48, then to 5.0Ap38), but it still got the same error.
>
>I worked on the AnsN# setting to no avail.
This is weird, as 6.1.7 was the solution found by someone with a similar
problem just recently (Geoff White).
Have you tried setting the "mynum" values in the line configurations
to all be empty, or all set to the lead number of the hunt group?
You *must* set the SPIDs correctly, but the directory numbers can be
set to match the incoming called-number (or blank - I believe).
Kevin Smith Ascend Communications...
Customer Satisfaction ...where Network Solutions never end.
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>
Follow-Ups:
References: