Ascend Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: (ASCEND) Max1800 5.0A=>6.1.7 upgrade misadventures
The number is blank in all the mynum entries.
> From Kevin A Smith Thu, Sep 03, 1998 at 03:56:54PM -0700
> At 01:02 PM 9/3/98 , Jerry Swann wrote:
> >Today, when I tried to upgrade a Max1800 from version 5.0A(b.m18)
> >to version 6.1.7, the pilot number to the box stopped working and
> >the serial hunt group no longer worked.
> >
> >The BRIs are off of a 5ESS switch. When we installed the lines
> >BellSouth couldn't get a UCD set up correctly without creating a
> >serial huntgroup among the lines. Because the UCD pilot wouldn't
> >work with a calling card, we publish the first number in the serial
> >huntgroup. All this worked until I upgraded the box.
> >
> >After upgrading, I could no longer get more than 1 user on the
> >box with the serial huntgroup number, and further attempts caused
> >a 'CALL REJECTED/OTHER DEST' error. I tried to down-grade (first
> >to 5.0Ap48, then to 5.0Ap38), but it still got the same error.
> >
> >I worked on the AnsN# setting to no avail.
>
> This is weird, as 6.1.7 was the solution found by someone with a similar
> problem just recently (Geoff White).
>
> Have you tried setting the "mynum" values in the line configurations
> to all be empty, or all set to the lead number of the hunt group?
> You *must* set the SPIDs correctly, but the directory numbers can be
> set to match the incoming called-number (or blank - I believe).
--
Jerry Swann "Jerry dot Swann at oit dot gatech dot edu"
Georgia Institute of Technology
Office Phone: 404 894-1659
Office Fax: 404 894-9548
++ Ascend Users Mailing List ++
To unsubscribe: send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd: <http://www.nealis.net/ascend/faq>
References: