Re: [TCLUG:10371] SMP and Adaptec 2940

[Peter Lukas <peter@math.umn.edu>]

Actually, that should have been Have you tried compiling the kernel
without SMP, but 2940 support?

Peter Lukas

On Mon, 22 Nov 1999, Peter Lukas wrote:

> Probably a tad late, but you are terminated and using the appropriate ID's
> in the chain?  Have you compiled direct 2940 support into your kernel?
> have you tried booting with the 7880.i floppy for Slakware 7?  Did you
> build the 7880 driver as a module (if so, did you make an initial ramdisk
> to load the image from)?  Have you tried compiling the kernel with
> SMP+2940 support?  How long did you specify the SCSI reset in your kernel
> compilation?
> 
> Peter Lukas
> 
> On Mon, 22 Nov 1999, Jon Schewe wrote:
> 
> > On Mon, 22 Nov 1999, Adam Maloney wrote:
> > 
> > > The board is a tyan S-1662 (440BX, I think) dual processor.  I'm using
> > > Pentium Pro 200/256k with SY032 stepping.  The SCSI card is an adaptec
> > > 2940U/W, and I'm using the aic7xxx driver in the kernel.
> > 
> > Try this, use the SMP kernel with only one processor and see what happens.
> > Perhaps there's something with the board having a second processor.  
> > 
> > -- 
> > Jon Schewe 
> > http://eggplant.mtu.net/~jpschewe
> > schewe@tcfreenet.org
> > 
> > 
> > ---------------------------------------------------------------------
> > To unsubscribe, e-mail: tclug-list-unsubscribe@mn-linux.org
> > For additional commands, e-mail: tclug-list-help@mn-linux.org
> > 
> > 
> 
> 
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: tclug-list-unsubscribe@mn-linux.org
> For additional commands, e-mail: tclug-list-help@mn-linux.org
> 
>