Re: [TCLUG:8308] Problems configuring an ISA Pnp Ethernet card

["Nathan Hartzell" <nhartzell@millermeester.com>]

I can use the DOS utility to configure it in Linux?  Sorry if this seems a
stupid question, I'm just starting with Linux.

-Nathan Hartzell

----- Original Message -----
From: Chris Kesler <chris@pconline.com>
To: <tclug-list@mn-linux.org>
Sent: Thursday, September 16, 1999 3:04 PM
Subject: Re: [TCLUG:8308] Problems configuring an ISA Pnp Ethernet card


> There is a DOS utility that you can run to configure that card.  It's
> called 3c5x9cfg.exe, and it's on the disk that came with the card.  You
> can probably download it from 3Com's site, too.  Anyways, you can use that
> configuration program to disable PnP and set an IRQ and IO address into
> the flash memory on the card.
>
>
> On Wed, 15 Sep 1999, Nathan Hartzell wrote:
>
> > I am attempting to install my 3com 3c509b ISA Ethernet card.  The module
> > loads under Linux, but the card does not initialize.  Attached is a copy
of
> > a pnpdump from my kernel and the output from isapnp in debug mode.
After
> > running isapn, the card still does not show up in lsmod.  Can anyone
tell me
> > what to do so that my card will initialize?  I am running Caldera
OpenLinux
> > 2.2 with no major updates.
> >
> > Thanks,
> > Nathan Hartzell
> >
> >
>
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: tclug-list-unsubscribe@mn-linux.org
> For additional commands, e-mail: tclug-list-help@mn-linux.org
>