(ASCEND) 7.2.3 for Pipelines 50/75/85 and Pipeline 220

[Matt Holdrege <holdrege@lucent.com>]

TAOS Release 7.3.2 for the Pipelines 50/75/85 and Pipeline 220 is available 
from Customer Support

This release contains the following:

Enhancements
* Lucent IPsec Client support
* NAT enhancements

Corrections
* TR 258752 When one of the LAN interface addresses was identical to the 
WAN interface address for single-address NAT, NAT deleted the route for the 
LAN interface address when the WAN link went down. This problem has been 
corrected.

* TR258753 The SuperPipe NAT translation table sometimes fills with 
non-existent TCP destinations that were permanently set to expire in 24 
hours. This timer is now configurable. Should this problem occur, set the 
Idle TCP Timeout parameter to a shorter period of time allowing the idle 
TCP NAT translation table entries to expire sooner.

* TR258640 The problem with the M-bit never being set in X.25 packets 
during binary data transfer has been corrected.

* TR5163 Configuring a Pipeline for international ISDN switch types, such 
as German and Swiss, which do not require SPIDS and My Num information, did 
not restore properly with the TRESTORE/FRESTORE monitor command. This 
problem has been corrected.

* TR250031 & TR5375 When BOOTP Relay forwards BOOTP requests, the IP 
lengths of those packets were set to a fixed value. Because the size of 
BOOTP requests (UDP length) can vary, the UDP length plus the IP header did 
not match the IP length. This problem has been corrected.

* TR5095 In Nortel's latest version of DMS100 switch software (411.20), 
there is an incompatibility with the Pipelines. This incompatibility has 
been corrected.


++ Ascend Users Mailing List ++
To unsubscribe:	send unsubscribe to ascend-users-request@bungi.com
To get FAQ'd:	<http://www.nealis.net/ascend/faq>