Re: [TCLUG:8308] Problems configuring an ISA Pnp Ethernet card

[Nathan Hartzell <nhartzell@macalester.edu>]

Well this is interesting.  When I run the config util, it comes up with an
"Run-time error R6003 --integer divide by 0".  Any ideas?  By the way, thank
you to everyone who has helped me with this so far.  It's nice to see that
people are so willing and able to help out others.

-Nathan Hartzell

----- Original Message -----
From: Christopher Palmer <reid@pconline.com>
To: <tclug-list@mn-linux.org>
Sent: Thursday, September 16, 1999 4:12 PM
Subject: Re: [TCLUG:8308] Problems configuring an ISA Pnp Ethernet card


> On Thu, 16 Sep 1999, Chris Kesler wrote:
>
> > There is a DOS utility that you can run to configure that card.  It's
> > called 3c5x9cfg.exe, and it's on the disk that came with the card.  You
> > can probably download it from 3Com's site, too.  Anyways, you can use
that
> > configuration program to disable PnP and set an IRQ and IO address into
> > the flash memory on the card.
>
> Yes. Also, Nathan, if your card has multiple media (twisted pair, coax
> and/or AUI -- some of those cards have all three instead of only tp), you
> have to set it to use the appropriate one. The DOS util does this also. I
> had the same problem, and David Carter figured it out for me back when I
> was a newbie. :)
>
>
> -- Chris
>
>   Christopher Reid Palmer : www.innerfireworks.com
>
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: tclug-list-unsubscribe@mn-linux.org
> For additional commands, e-mail: tclug-list-help@mn-linux.org
>